Product Introduction
Technical Specifications
| Parameter | Value/Description |
|---|---|
| Treatment Effect | Inlet water ≤ 20NTU ，outlet water SDI ≤ 3 Inlet water ≤ 20NTU ，effluent turbidity ≤ 0.1NTU When the incoming water quality is poor, special analysis should be conducted |
| Operating parameters | Maximum water temperature:5~40℃ PH tolerance range:1-12 |
| Running parameters | Produced water flux:30-100L/ ㎡ -h Backwash flux:90-150L/ ㎡·h Maximum inlet pressure:0.5MPa Maximum transmembrane differential pressure:0.2MPa Maximum backwashing differential pressure:0.2MPa Filtration cycle:15-60min Backwashing time:30-180s |
| Cleaning parameters | Chemically Enhanced Backwashing (CEB) Frequency:0-24 times/day |
| Frame material | Stainless steel, carbon steel coated with epoxy resin |
| Operation Mode | Full or cross flow, timed backwash |
Working Process
During the ultrafiltration process, the aqueous solution flows through the membrane surface under pressure. The solvent (water) and small molecular solutes smaller than the membrane pores permeate the membrane and become purified liquid (filtrate), while the solutes larger than the membrane pores are retained and discharged with the water flow to become concentrated liquid.There are two modes of ultrafiltration operation: full-flow filtration (dead-end filtration) and cross-flow filtration. In full-flow filtration, all the influent water passes through the membrane surface to become produced water; while in cross-flow filtration, part of the influent water passes through the membrane surface to become produced water, and the other part is discharged with impurities to become concentrated water. Full-flow filtration has low energy consumption and high recovery rate, so the operating cost is lower; while cross-flow filtration can treat fluids with higher suspended matter content. The specific operation mode should be determined according to the suspended matter content in the water.
Product Features
- The separation process does not cause phase change, and does not cause changes in temperature and pH,thus preventing the denaturation, inactivation and autolysis of biomacromolecules;
- The separation process can be carried out at normal temperature and consumes little energy; The separation process is driven only by low pressure, the equipment and process flow are simple, the cost islow, no chemical reagents are required, and it is easy to operate, manage and maintain;
- The application range is wide. Ultrafiltration separation technology can be used for solutes with molecular weights of 1000~500000 Daltons or solute sizes of about 0.03~0.1μm.
Application Fields
- Drinking water, ultrafiltration only removes suspended solids, colloidal particles, bacteria and other impurities in the water, and retains the minerals that are beneficial to human health.
- Municipal, family, school, restaurant, hotel, commercial, rural water; pure water before / after treatment.
- Desalination, pharmaceutical water, chemical industry pure water system, biological engineering system, food and beverage pure water system.
- Water, sewage, waste water treatment and reuse.
- Oily wastewater, heavy metal wastewater, textile printing and dyeing wastewater, paper industry wastewater, municipal sewage treatment.
- Special solution separation and concentration.
- Concentration and separation of biotechnology, purification of Chinese medicine preparation, concentration and removal of impurities, starch recycling applications, food and beverage concentration and clarification applications.
